BMW X5 Oil Reset: How to

The oil-service reminder should only be reset after the engine oil and oil filter have been replaced. Resetting the reminder does not change the oil level, repair an engine problem, or clear a genuine low-oil warning.

The exact procedure depends on the model year and instrument cluster fitted to the vehicle.

2019 and Newer BMW X5 — G05

1. Park the vehicle safely and switch off the engine.
2. Do not press the brake pedal.
3. Quickly press the Start/Stop button three times to activate Diagnostic Mode.
4. Wait until the instrument cluster displays a message such as “Diagnostic Mode Active.”
5. BMW X5 Oil Reset: Press and hold the BC button on the end of the turn-signal stalk for approximately 10 to 20 seconds.
6. Release the button when the service-reset menu appears.
7. Press the BC button briefly to scroll through the available maintenance items.
8. Stop when “Engine Oil” or the oil-can symbol is displayed.
9. Press and hold the BC button until “Reset?” or “Reset Possible” appears.
10. Release the button, then press and hold it again to confirm.
11. Wait until the display shows “Reset Successful” or a new service date and mileage.

After completing the reset, switch the ignition off and restart the vehicle. Check the engine-oil service information through the iDrive Vehicle Status or Service Requirements menu.

2007–2018 BMW X5 — E70 and F15

1. Sit in the vehicle and close the driver’s door.
2. Do not press the brake pedal.
3. Press the Start/Stop button once to switch on the ignition without starting the engine.
4. Wait for the warning messages on the instrument cluster to disappear.
5. BMW X5 Oil Reset: Press and hold the trip-odometer reset button on the instrument cluster.
6. Continue holding it until the maintenance-service menu appears.
7. Release the button, then press it briefly to scroll through the service items.
8. Select the engine-oil item or oil-can symbol.
9. Press and hold the button until “Reset?” appears.
10. Release the button, then press and hold it again to confirm the reset.
11. Wait for the reset process to finish before switching off the ignition.

If the Reset Does Not Work

Make sure the engine is off and the brake pedal is not being pressed. The button may need to be held for 10 seconds or longer before the service menu appears.

A message such as “Reset Impossible” or “Reset Unsuccessful” may indicate that the service interval is not ready to be reset, the wrong maintenance item was selected, the battery voltage is low, or the vehicle has a fault stored in the CBS maintenance system.

Do not accidentally reset other items such as the front brake pads, rear brake pads, brake fluid, or vehicle inspection. Each maintenance item is recorded separately.

Because the procedure can vary slightly depending on the production year, instrument cluster, and software version, consult the vehicle’s owner’s manual or use the VIN to confirm the correct procedure for your specific BMW X5.